These parts are for the Creality CR10 and CR10S models. They may also fit the larger versions the 400/500 as well.
Easy installation assembles with m3 screws (not included).
This assembly accepts an E3D v6 extruder, even the clones of the E3D with a top bowden lock connector.
You will also need to source a Skate bearing (608-RS) ABEC-9
and a flat washer 11mm OD x 3mmID to secure the bearing into the assembly.
Also it is recommended to purchase a pancake stepper that will reduce weight and provide a more compact profile once mounted.
Stepperonline.com is a good source for pancake steppers and has all the details relating to torque and voltages. Although you may use the existing stepper that is already on your CR10’s extruder if you wish.
Additionally Fang style cooling ducts are also available that make the perfect match for the Direct Drive assembly. Cooling ducts come in 2 types that receive auto bed leveling devices such as the BLTOUCH and The ABL System.
Dual Ducting setup requires a pair of DC Blower Fan 5015S 12V 2 Wires 50x50x15mm Sleeve. A wide variety of sellers on Amazon have options available. LINK Fan wires for the cooling ducts can be wired together and ran to the same location on your controller board.
The extruder body cooling fan is a 12V DC 30mm Cooling Fan also available on Amazon and is of the type typically used on 3D Printers. LINK
Finally you will need a couple inches of 4mm Bowden tube to make entry into the top of the Direct Drive Assembly to direct the filament between the knurled gear (MK8) and the 608 Bearing. Bearing tension is set simply by squeezing the assembly against the filament between the bearing and the MK8 Gear Then tightening the stepper motor on the assembly, No springs or levers required.
All parts are printed in Esun PETG in the colors Blue, Red & Black. Make selections when adding to cart.